Back to Gunite Pools
CambridgeNothing beats a heater for adding comfort to early morning lap sessions, after-dark swims or to extend your swim season to earlier in the spring or later in the fall. The key to pool heating economy is combustion efficiency...making sure the heat that is generated is transferred to the pool water with as close to 100% efficiency as possible. Our high efficiency gas heaters heat up fast. They are economical to run. And they're built to last. Cambridge Paving |
Stamped ConcreteMATCRETE® Aluminum Pattern Imprinting Stamp Tools™ are the original cast-in-place concrete stamps.These tools provide an imprinted pattern that leaves a smooth surface and deep joints. MATCRETE® Aluminum Pattern Imprinting Stamp Tools™ are the original cast-in-place concrete stamps. These tools provide an imprinted pattern that leaves a smooth surface and deep joints. Matcrete Stamped Concrete |
EP HenryUnlike asphalt, pavers are virtually maintenance-free. By definition, concrete pavers have a minimum compressive strength of 8,000 psi (about 3 times stronger than regular poured concrete) and a maximum water absorption rate of 5%. EP Henry Pavers |
ArtisticElegant, rich, classy, and natural looking...Artistic Pavers have colors and textures that enhance the look of your pool and deck. They are not colored “porous block type” bricks that you would expect to see in a driveway. Artistic Pavers |
Brushed ConcreteSalt Finish and Broom Finish are both selections of concrete decks that are categorized by the texture and method of installation. Broom finish decks are brushed with a broom as the concrete cures, giving it a brushed look. Salt, on the other hand, gets its name from the texture pits etched and created when rock salt is hand broadcast over the deck as it cures. Either surface can be enhanced with mixed in or topical color, as well as a variety of stains. |
CantileverStegmeier's Cantilever Forms are foam forms that attach to the tile on gunite (or one-piece fiberglass) pools and secured with double face tape and tie wires. The tie wires are positioned approximately 14" apart and are designed to break away at a pre determined point 2" deep into the concrete edge. |
